Besa Lighting Sprite (Mini Pendants 12V) - Manual (Page 3)

6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
IMPORTANT: For installation of pendants and wiring, please refer
to the Fixture Installation Guide included with fixture canopy
GLASS SHADE INSTALLATION GUIDE
Relamp with a low-pressure type lamp,
either xenon or halogen. Packaging of
this lamp will typically indicate that it’s
“Suitable For Use in an Open Fixture”
or marked with the symbol shown.
Lower Hex Nut
Socket Assembly
Figure 1
Figure 2
Lamp
Threaded Nipple
Lamp
Upper Hex Nut
Decorative Cap
IMPORTANT:
The pendant and glass assembly you have received is designed
such that the glass must be installed prior to hanging the pendant.
1. Begin by threading the Treaded Nipple into the top of the Socket Assembly and
secure using the Lower Hex Nut provided, as shown by figure 1.
While holding the Lampholder secure, hold the Lamp by the base, just above
the contacts, and firmly push the lamp into the socket. See figure 1.
NOTE: Lampholder is designed to have a tight fit, so resistance may be
experienced when inserting lamp.
2. Following figure 2, the glass shade (shape may vary) will be positioned as shown.
Depending on the thickness of glass, the Upper Hex Nut may require adjustment to
allow the Decorative Cap to properly seat at top the glass shade.
While performing the remaining instruction steps, care must be taken to keep
the glass shade and assembly protected, otherwise breakage may occur.
Use With
these Models:
• Sprite
(1716xx)