Besa Lighting 3061 Series (Costaluz) - Manual (Page 2)

FIXTURE INSTALLATION GUIDE
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
Models using T930 bracket (Wall Lantern 120V)
T930, Rev.3 9-12
CAUTION: Turn off power to electrical box before installing
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
1. Carefully remove parts from package.
2. Remove the two Decorative Cap Nuts (A) to release the Mounting Bracket (B).
3. Attach the Mounting Bracket to the Outlet Box (C) with two Machine Screws (D) provided.
4. Connect the electrical leads from the fixture to the house supply wires, black to black
and white to white, and secure with wirenuts provided (E). Attach the house ground wire
to the bare copper lead from the Canopy (F), and secure with the provided wirenut.
5. Align the circular openings on the canopy with the Threaded Posts (G) on the
Mounting Plate. Push the Canopy over the Threaded Posts until the Canopy
is flush with the wall, then secure with the Decorative Cap Nuts.
6. IMPORTANT: IN ORDER TO COMPLY WITH ESTABLISHED ELECTRICAL CODES,
THE INSTALLER MUST SEAL THE AREA BETWEEN THE CANOPY AND THE WALL
WITH CAULKING COMPOUND. THIS SHALL BE A TYPE SUCH AS SILICONE TO
PROVIDE A WATERTIGHT SEAL WITH THE WALL.
7. With the power still off, insert bulb of not more than the labeled wattage.
8. Place the glass onto the canopy and secure with the two retaining screws (H).
Do not overtighten the retaining screws.
9. Restore power.
A
B
C
D
E
F
G
H