Besa Lighting Pahu 4 (Mini Pendants 12V) - Manual (Page 3)

All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
GLASS SHADE INSTALLATION GUIDE
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
Relamp with a low-pressure type lamp,
either xenon or halogen. Packaging of
this lamp will typically indicate that it’s
“Suitable For Use in an Open Fixture”
or marked with the symbol shown.
1. Begin by threading the Treaded Nipple into the top of the Socket Assembly and secure using the
Lower Hex Nut and Washer provided. Then secure the Support Block using the Upper Hex Nut
and Decorative Cap provided. See figure 1.
IMPORTANT: For ease of installation, the lamp may be installed now, prior to installation of the glass.
2. Following figure 2, the glass shades (shapes may vary) will be positioned as shown. Align inside
glass shade so that the Support Posts easily fit through the side holes in the inside glass shade
and align with the holes in the Support Block and then thread the Support Posts into the Support
Block holes. Next, align outside glass shade so that the Decorative Posts easily fit through the side
holes in the outside glass shade and align with the holes in the Support Posts and then thread the
Decorative Posts into the Support Posts holes.
For lamping, plug the provided 35W Lamp provided. For relamping never exceed 35 watts,
as greater wattages could cause overheating, adversely affecting the life of the luminaire.
While performing the remaining instruction steps, care must be taken to keep
the glass shade and assembly protected, otherwise breakage may occur.
Lower Hex Nut
and Washer
Socket
Assembly
Figure 1
Figure 2
Lamp
Threaded
Nipple
Upper Hex Nut
Support Block
Support Block
Inside Glass
Decorative Post*
Decorative Cap
Outside Glass
Support Post
*-Decorative Posts
provided may vary in
appearance, than as
shown
Use With
these Models:
• Pahu 4
(x44007)