Besa Lighting Tara (120V Pendants) - Manual (Page 2)

INSTALLATION GUIDE
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
Using a Continuity Tester or Multimeter,
confirm the following connections:
• Clear Conductor with White Stripe (Neutral/White)
is connected to the Socket Screwshell. This wire is
to be connected to house supply white conductor.
• Clear Conductor (Hot/Black) is connected
to the Socket Center Contact. This wire is
to be connected to house supply black wire.
SOCKET
SCREWSHELL
SOCKET
CENTER CONTACT
POLARITY INSTRUCTIONS
7. Secure Glass Shade, then install
bulb per label on luminaire.
8. Restore power.
J
6. Replace the Canopy as shown and secure with the Retainer. Tighten
the Retainer enough to hold the Canopy to the ceiling but do not
overtighten. The cord can now be shaped by positioning the Cord
Rings (J) along the cable as desired.
Overtightening can cause the Retainer to be difficult to unscrew.
If this occurs, usually rotating the canopy counter-clockwise will
help to unlock the Retainer.
Threaded Posts
Glass Shade
The Center Fitter
must be installed prior
to installing cord into
the ceiling canopy.
*-Threaded Posts provided may
vary in appearance, than as shown
Use With
these Models:
• Tara
(4127xx)