Besa Lighting Brella (Mini Pendants 12V) - Manual (Page 3)

All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
IMPORTANT: for installation of pendants and wiring, please refer
to the FIXTURE INSTALLATION GUIDE included with fixture canopy
GLASS SHADE INSTALLATION GUIDE
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
Prior to installing Pendant Cord
Set to Fixture,the Decorative Cap
and Threaded Nipple must be
installed. The Decorative Cap and
Threaded Nipple do not need to
be secured at this time.
While holding the Lampholder
secure, hold the Lamp by the base,
just above the contacts, and firmly
push the lamp into the socket.
NOTE: Lampholder is designed
to have a tight fit, so resistance
may be experienced when
inserting lamp.
Install the Glass Shade by positioning up over
the Lampholder and thread on the Check Ring
completely, as shown.
This Pendant Cord Set has been designed to
allow the Glass Shade to either rest freely or
to be locked in position. To lock down Glass
Shade, adjust the Threaded Nipple as shown.
Otherwise, thread completely into Lampholder.
NOTE:
If the Threaded Nipple can not extend to 11/16”,
lower the Check Ring as needed.
11/16”
NOTE:
Glass Shade is for
instructional purposes.
Actual Glass Shade may
vary in size and shape.
Check Ring
Lower the Decorative Cap down
onto the Glass Shade.
Lamp
Decorative Cap
Lampholder
Threaded Nipple
Relamp with a low-pressure type lamp,
either xenon or halogen. Packaging of
this lamp will typically indicate that it’s
“Suitable For Use in an Open Fixture”
or marked with the symbol shown.
Use With
these Models:
• Domi
(1743xx)
(1843xx)
(5743xx)
• Brella
(4679xx)
• Spazio
(6294xx)