beautypg.com

Every six months, Storing the cutter, Lubricating the cam shaft – Belshaw Adamatic Type F Cake Donut Depositor User Manual

Page 9: Lubricating the gears and the clutch

background image

Belshaw Adamatic Bakery Group

[email protected]

 Phone 206-322-5474  Fax 206-322-5425

4

MN-1531EN

Donut Cutter Type F OM

4. Wipe the excess oil from the trip arms and

the cam case.

5. Put the frame assembly back on the pivot

arm pin.

6. Re-install the plunger, hopper, and trip arm

guard.

Lubricating the Cam Shaft

Once a week, lubricate the camshaft as follows:

1. Disconnect the machine from the power

source.

2. Loosen the wing nut that holds the crown

bearing in place.

3. Turn the dial so the trip arms spread apart.

4. Use a narrow paintbrush to apply edible-

grade grease to the camshaft through the
opening between the trip arms.

5. Hand-tighten the wing nut that holds the

crown bearing in place.

Lubricating the Gears and the
Clutch

The oil in the gearbox should come up all the
way to the fill hole, which is located on the lower
part of the gearbox. Once a week, check the
level of the oil and, if necessary, add oil, as
follows:

1. Make sure the F machine is mounted in the

upright operating position.

2. Remove the plug from the fill hole.

3. Check the oil level.

4. If necessary, pump 90-weight oil into the

gearbox until it begins to overflow.

5. Allow the excess oil to drain out of the hole.

6. Replace the plug.

7. Wipe the oil off of the gearbox exterior.

Every Six Months

Every six months replace the oil in the gearbox
as follows:

1. Remove the trip arm guard, hopper, and

plunger.

2. Lift the frame assembly off of the pivot arm

pin.

3. Remove the plug from the fill hole.

4. Allow the oil to drain from the gearbox into

a suitable container.

5. Recycle or dispose of the used oil properly.

6. Pump 90-weight oil into the gearbox until it

begins to overflow.

7. Allow the excess oil to drain out of the hole.

8. Replace the plug.

9. Wipe the oil off of the gearbox exterior.

10. Put the frame assembly back on the pivot

arm pin.

11. Install the plunger, hopper, and trip arm

guard.

Storing the Cutter

If the cutter is to be stored for any length of time,
please use the following procedure:

Store the cutter upright. If it cannot be stored
upright, drain the oil from the gear box. (The
gearbox is not “watertight,” and should not be
sprayed with water for cleaning purposes).