Belshaw Adamatic Type F Cake Donut Depositor User Manual
Page 23
Belshaw Adamatic Bakery Group
Phone 206-322-5474 Fax 206-322-5425
8
MN-1533EN
Donut Cutter Type F TS
THE MOTOR WILL NOT START.
Possible Causes
What To Do
The machine is not connected to a proper power
source.
Connect the machine to a proper power source, as
specified on the data plate.
The circuit breaker has been tripped.
Press the red reset button.
THE MOTOR SHUTS OFF WHEN THE CLUTCH IS ENGAGED.
Possible Cause
What To Do
The plunger is jammed at the base of the hopper
cylinder.
Clear away the cause of the obstruction. Plug in
and turn on the machine. Press the red reset
button.
THE DONUTS DO NOT DROP STRAIGHT OR SEPARATE FROM THE
CYLINDER EVENLY.
Possible Causes
What To Do
The machine frame is out of alignment.
Send the machine to the factory for service.
The cylinder is dirty.
Clean the cylinder as explained in Section 3,
“Cleaning.”
THE MACHINE MAKES CLICKING OR BANGING NOISES.
Possible Cause
What To Do
The machine frame is out of alignment.
Send the machine to the factory for service.
THE DONUTS VARY IN SIZE.
Possible Causes
What To Do
The hopper and the cylinder are not joined tightly
enough.
Tap down lightly on the top of the hopper.
The plunger pistons are worn or undersized.
Replace the plunger.