Belshaw Adamatic Type F Cake Donut Depositor User Manual
Page 24
Belshaw Adamatic Bakery Group
Phone 206-322-5474 Fax 206-322-5425
Donut Cutter Type F TS
MN-1533EN
9
THE OUTER AND INNER DIAMETERS OF THE DONUTS ARE TOO LARGE.
Possible Cause
What To Do
The donuts are falling too far, causing them to
turn after they drop.
Adjust the height of the machine so there is less
distance between the bottom of the machine and
the frying screen. Do this by moving the set collar
on the mounting column or bushing.
UNWANTED DOUGH IS DEPOSITED ON THE PRODUCT.
Possible Causes
What To Do
The plunger is worn.
Replace the plunger.
The cylinder is worn.
Replace the cylinder.
The cylinder lip is damaged.
Replace the cylinder.
THE MACHINE JAMS.
Possible Causes
What To Do
The machine frame is out of alignment.
Send the machine to the factory for service.
There is an obstruction in the cylinder.
Clear the cause of the obstruction.
The plunger is bent.
Replace the plunger.
WHEN USING THE BALL PLUNGER, THE BALLS STICK TOGETHER.
Possible Cause
What To Do
The cutter is too far above the shortening.
Adjust the height of the machine so the end of the
plunger touches the shortening when the balls are
extruded. Do this by moving the set collar on the
mounting column or bushing.
WHEN USING THE BALL PLUNGER, THE BALLS VARY IN SIZE.
Possible Cause
What To Do.
One of the holes in the plunger piston is clogged
with batter.
Remove the plunger and clean it.