beautypg.com

Installing the column – Belshaw Adamatic Type F Cake Donut Depositor User Manual

Page 18

background image

Belshaw Adamatic Bakery Group

[email protected]

 Phone 206-322-5474  Fax 206-322-5425

Donut Cutter Type F TS

MN-1533EN

3

comply with CE standards, unless you have
this work done by a qualified technician.

4. Thread a 1/4-20 bolt through each of the

holes in the fryer’s feet and into the floor.

WARNING

When the machine is column-mounted on a

fryer, make sure the fryer is securely

fastened to the floor. If the fryer is not

fastened to the floor, the weight of the

cutter could cause the fryer to tip over,

resulting in serious burns, other injury, or

death.

Installing the Column

To install the column, follow the instructions
appropriate for your fryer. The four sets of
instructions below explain how to install the
column on the following fryers:

 Pre-1990 Belshaw Open-Kettle Electric

Fryers;

 Other Belshaw Open-Kettle Fryers (this

includes all Belshaw Open-Kettle Gas
Fryers, and Belshaw Electric Fryers
manufactured since 1990);

 Belshaw Century fryers; and
 Non-Belshaw Fryers

Pre-1990 Belshaw Open-Kettle Electric
Fryers
To install the column on a Belshaw electric fryer
made before 1990, follow these steps:

1. Slide the column mounting brackets onto the

column.

2. Remove the six nuts and washers from the

mounting blocks on the back of the fryer
cabinet.

3. (On older Belshaw fryers with narrow kettle

flanges, there are no mounting blocks. The

mounting holes are pre-punched in the sheet
metal cabinet.)

4. Slide the mounting brackets onto the bolts.

5. Replace the washers and nuts you removed

in step 3, and tighten the nuts.

6. With the column resting on the floor, secure

the column by tightening the two 5/16-18 x
1” square head set screws (provided) in the
mounting brackets.

Other Belshaw Open-Kettle Fryers
Read this section if you want to column-mount
the Type F Donut Cutter on a Belshaw open-
kettle gas fryer or on a Belshaw open-kettle
electric fryer manufactured since 1990. To
install the column, follow these steps:

1. Slide the column mounting brackets onto the

column.

2. There is a mounting plate on the side of the

fryer cabinet; the plate has two sets of three
holes in it. Align the holes in the mounting
brackets with these holes. Fasten the
mounting brackets to the plate using the six
lock washers and 5/16-18 x 1” hex-head
screws provided.

3. With the column resting on the floor, secure

the column by tightening the two 5/16-18 x
1” square head set screws (provided) in the
mounting brackets.

Belshaw Century Fryers
To install the column on a Belshaw Century
Fryer, follow these steps:

1. Have a qualified technician use an

appropriate tool to create holes in the fryer’s
frame assembly for installing the column
mounting brackets.

2. We cannot guarantee that the Type F Donut

Cutter or the Century Fryer will comply with
CE standards unless you have this work
done by a qualified technician.

3. Slide the column mounting brackets onto the

column.