Belshaw Adamatic Type F Cake Donut Depositor - Manual (Page 21)

Belshaw Adamatic Bakery Group  [email protected]  Phone 206-322-5474  Fax 206-322-5425
6 MN-1533EN Donut Cutter Type F TS
4. Turn motor on.
5. With motor running, finish tightening the
hex nuts underneath the motor spacers.
Tighten in an alternating sequence (not one
after another in a circle).
6. This allows the motor to properly center the
drive shaft.
WARNING
Failure to install the motor in the above
manner can cause the shaft to wear
improperly and break.
Installing the Motor
Coupling Covers
Install the motor coupling covers (2) around
motor spacers, using the two sheet metal screws
provided.
Installing the Plunger and
Hopper
To install the plunger and the hopper on the
cutter, follow these steps:
1. Open the hinge clamp at the bottom of the
frame, if it is not open already. To open it,
loosen the wing nut and swing the hinge
clamp bolt out of the slot.
2. Put the plunger in the hopper. Put one of
your hands underneath the hopper cylinder
so the plunger does not fall out.
3. Slide the plunger’s locating pins into the
slots on the ends of the trip arms.
4. Slide the cylinder into the opening at the
bottom of the frame.
5. Swing the hinge clamp around the cylinder,
swing the hinge clamp bolt into the slot, and
hand-tighten the wing nut that holds the
hinge clamp shut.
6. Install the trip arm guard assembly. The
crown bearing, which is mounted inside the
trip arm guard, must pass over the plunger
center rod and into the cylindrical opening
in the frame. The safety key, which is also
mounted inside the trip arm guard, must
connect with the safety interlock switch.
7. Hand-tighten the wing nut that holds the
crown bearing in place. The wing nut can
be reached through the opening in the side
of the trip arm guard.