Belshaw Adamatic Type F Cake Donut Depositor - Manual (Page 16)

Belshaw Adamatic Bakery Group  [email protected]  Phone 206-322-5474  Fax 206-322-5425
Donut Cutter Type F TS MN-1533EN 1
1 Installation
Unpacking and Initial
Cleaning
To unpack the Type F Donut Cutter, transport it
to the workstation, and clean it:
1. Remove all the parts of the machine from
the shipping containers.
2. Carefully carry the parts to the workstation.
Observe proper lifting techniques.
3. Remove all packing materials from the
machine.
4. Wipe the hopper, plunger, and other parts of
the machine with a damp cloth.
WARNING
To avoid electrocution and equipment
damage, do not allow any water to enter
the motor.
5. Dry all the parts.
Preparing to Mount the
Cutter on the Wall
1. Have a qualified technician provide a solid
support on the wall, as explained below. We
cannot guarantee that the Type F Donut
Cutter will comply with CE standards unless
you have this work done by a qualified
technician.
a. Cut a good-quality board (at least 2”/
5 cm thick by 4”/10 cm wide) so that it
extends from the floor to the ceiling of
the bakery.
b. Attach the board to a wall stud using #4
wood screws, at least 4”/10 cm long.
Space the screws every 12”/30.5 cm
along the entire length of the board.
2. Drill holes for mounting the fryer, as
follows:
a. Position the fryer 6-8”/15-20 cm from
the wall, slightly to one side of the
board. Level the fryer.
b. Lay a straight edge across the top of the
fryer kettle so that it touches the board.
c. With a pencil, mark the board where the
bottom of the straight edge touches it.
This mark indicates the height of the top
of the kettle.
d. With a pencil, mark the board 15”/38 cm
above the kettle height, in the center of
the board.
3. Using an appropriate tool, make a
1/4”/0.635 cm diameter hole at this point.
Installing the Wall Plate
1. Attach the wall plate to the wall support by
screwing a 5/16” x 1-1/2” lag screw
(provided) through the top hole of the wall
plate.
2. Use a level to make sure the wall plate is
hanging vertically.
3. On the mounting board, mark the locations
of the five other holes in the wall plate.
4. Using an appropriate tool, make holes at
these five locations.
5. Screw the five remaining lag screws through
the five remaining holes in the wall plate.