Belshaw Adamatic Type F Cake Donut Depositor - Manual (Page 19)

Belshaw Adamatic Bakery Group  [email protected]  Phone 206-322-5474  Fax 206-322-5425
4 MN-1533EN Donut Cutter Type F TS
4. Align the holes in the column mounting
brackets, with the holes in the fryer frame
assembly.
5. Secure the mounting brackets to the frame
using the 5/16-18 x 1” hex-head screws
provided.
6. With the column resting on the floor, secure
the column by tightening the two 5/16-18 x
1” square head set screws (provided) in the
mounting brackets.
Non-Belshaw Fryers
If you have a non-Belshaw Fryer, check in the
Technical Supplement to see whether Belshaw
makes an adapter kit for it. If we do, order the
adapter kit and install the column according to
the instructions that come with the kit.
To install the column on a non-Belshaw fryer for
which we do not make an adapter kit, follow
these steps:
1. Slide the column mounting brackets onto the
column.
2. Chose a location to mount the column. You
should mount the column on the side of the
fryer the operator will stand on, on the rear
corner. You may mount the column either
on the side, or on the back of the fryer,
provided that the cutter will be able to move
freely.
3. Have a qualified technician use an
appropriate tool to create holes in the fryer
cabinet for installing the column mounting
brackets. We cannot guarantee that the
Type F Donut Cutter will comply with CE
standards, unless you have this work done
by a qualified technician.
4. Secure the mounting brackets to the fryer
using 5/16-18 machine screws, 5/16 flat
washers, 5/16 lock washers, and 5/16-18 hex
nuts.
5. With the column resting on the floor, secure
the column by tightening the two 5/16-18 X
1” square head set screws (provided) in the
mounting brackets.
Installing the Swing Arm
1. Slide the set collar onto the column.
2. Slide the straight-arm section onto the
column.
3. Put the pivot arm section between the legs of
the straight arm.
4. Put the extension arm-limiting bracket
between the legs of the pivot arm. The holes
in the extension arm limiting bracket, pivot
arm, and straight-arm must line up. (You do
not need to use the extension arm-limiting
bracket if you are mounting the machine to a
Belshaw Century fryer.)
WARNING
You must use the extension arm limiting
bracket when column-mounting the Type F
Donut Cutter to a Belshaw 618, 618L, 624,
718LG, or 724G fryer, or to any fryer that
is 24”/61 cm square or smaller. If you do
not, the fryer might tip over when the
cutter is swung away from the fryer,
resulting in serious burns, other injury, or
even death.
5. Slide the arm pin through the holes in the
straight-arm, pivot arm, and extension arm-
limiting bracket.