Belshaw Adamatic Type F Cake Donut Depositor - Manual (Page 7)

Belshaw Adamatic Bakery Group  www.belshaw.com  Phone 206-322-5474  Fax 206-322-5425
2 MN-1532EN Donut Cutter Type F OM
2 Cleaning
Clean the Type F Donut Cutter after every use.
Follow these steps:
1. Turn the motor off and disconnect the
machine from the power source.
WARNING
To avoid electrocution or other injury,
unplug the machine before cleaning.
2. Put one of your hands underneath the
cylinder.
CAUTION
If you do not keep your hand under the
cylinder when you loosen the plunger, the
plunger will fall on through and be
damaged.
3. Loosen the wing nut that holds the crown
bearing in place.
4. Remove the trip arm guard.
5. Loosen the wing nut that holds the hinge
clamp in place.
6. Open the hinge clamp and remove the
hopper, and the plunger, by pulling them
forward.
7. If desired, remove the cylinder from the
hopper. If you cannot remove it at first, run
hot water on the hopper and cold water on
the cylinder, and try again.
8. Wash the cutter, hopper, and cylinder
separately, using warm water, a mild
detergent, and a non-abrasive scrubber.
9. Rinse these parts in clear water.
10. Dry the parts.
11. If desired, wipe the rest of the machine using
a damp cloth.
WARNING
To avoid electric shock, serious burns, and
equipment damage, never allow water to
enter the cutter head or the motor.