Belshaw Adamatic Type F Cake Donut Depositor User Manual
Page 25
Belshaw Adamatic Bakery Group
Phone 206-322-5474 Fax 206-322-5425
10
MN-1533EN
Donut Cutter Type F TS
WHEN USING THE STICK PLUNGER, THE STICKS BEND AND ARE
POORLY SHAPED.
Possible Causes
What To Do
The sticks are too large.
Turn the short crank on the dial to decrease the
size of the sticks.
The cutter is too far above the shortening.
Lower the cutter. Do this by moving the set collar
on the mounting column or bushing.
WHEN USING THE KRINKLE PLUNGER, THE PRODUCT IS SHAPED
IRREGULARLY.
Possible Cause
What To Do
The former flutes are plugged with batter.
Disassemble and clean the plunger.
THE LOWER PISTON AND THE FORMER OF THE KRINKLE PLUNGER
CANNOT BE REMOVED FOR CLEANING.
Possible Cause
What To Do
The lower piston and the former are stuck to the
center rod, probably due to corrosion.
Soak the plunger in oil for 24 hours. Tap the
lower piston and the former lightly with a rubber
hammer to loosen them.