Belshaw Adamatic Type F Cake Donut Depositor - Manual (Page 27)

Belshaw Adamatic Bakery Group  [email protected]  Phone 206-322-5474  Fax 206-322-5425
12 MN-1533EN Donut Cutter Type F TS
Adjusting the Spacing of
the Trip Arms
If the machine becomes jammed, the trip arms
may go out of adjustment. Therefore, you should
check the spacing of the trip arms after any
jamming has occurred. Also, you should check
the spacing of the trips arms if doing so is
suggested in “Troubleshooting.”
To check and adjust the spacing of the trip arms,
follow the procedure below, referring to Figure
2-2. All dimensions given are
 0.020”/0.051
cm.
1. Turn off and unplug the machine.
WARNING
To avoid being seriously injured or
electrocuted, turn off and unplug the
machine before making adjustments.
2. Set the donut size to #3, the maximum setting
on the dial.
3. Turn the dial by hand until the lower trip arm
is in its lowest position.
4. Check dimension A. If necessary, bend the
lower trip arm until this dimension is
11.063”/28.100 cm.
5. Turn the dial until the upper trip arm is in its
lowest position.
6. Check dimension B. If necessary, bend the
upper trip arm until this dimension is
12.53”/31.83 cm.
7. Turn the dial until the pointer on the short
rank points straight down.
8. Check dimension C. If this dimension is not
2.65”/6.73 cm, some of the parts in your
machine may be worn and need to be
replaced.
9. Turn the dial until the pointer on the short
crank points straight up.
10. Check dimension D. If this dimension is not
0.94”/2.39 cm, some of the parts in your
machine may be worn and need to be
replaced.
Figure 2-2. Adjusting the Spacing of the Trip
Arms.
Frame
Trip
arms
C D
A B