Avery Dennison Monarch 9864 Verifier - Manual (Page 2)

I n s t a l l i n g t h e V e r i f i e r
To install the verifier:
1. Remove the knife module if the printer has one installed.
2. Use a 4mm hex wrench to attach the mounting arm to the printer. Use the two
screws from the knife's mounting or the screws already on the printer.
Attach these screw s
3. Replace the printer's cover. The verifier requires a special cut-out cover. Call
Service if you did not receive a cut-out cover.
4. Using a Philips screwdriver, remove the four screws from the printer's cover. The
notch in the supply holder lines up with the screw as shown.
Remove these
screw s
5. Remove the current cover and set it aside.
6. Attach the cut-out cover to the printer with the four Philips screws. The notch in the
supply holder lines up with the screw as shown.
2