Avery Dennison SNAP 500 Operator Guide - Manual (Page 29)

User’s Manual—SNAP™ 500 29
6. Remove the new print head from the anti-
static bag.
7. Place the new print head assembly onto the plastic
mount bracket underneath the print station.
8. Carefully, align the clips into the bracket as shown.
Push it up until it clicks into position.
9. Reconnect the print head cable connectors, making sure that the connectors are seated
tightly.
WARNING: If the cables are not connected correctly, the print head
will be destroyed when the power to the printer is turned
on. Check to see that the cable is tight by observing from
underneath the print head.