Avery Dennison ALX 924 Setup Manual - Manual (Page 9)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
9
9. Peel labels off the backing paper for a
stretch of appr. 50 cm [8].
10. Open the pressure roller lever [9A] by
pressing it downwards.
11. Pull the backing paper backwards under-
neath the printing module and insert it as
illustrated [9].
12. ALX 925/926: Loosen the two thumb
screws [10B] at the spring-suspended
blocks. Position the spring-suspended
blocks [10A] in a way that the contact rolls
press symmetrically on the backing paper.
Retighten the thumb screws.
ALX 924: Loosen the thumb screw [10B].
Position the spring-suspended block [10A]
in a way that the contact roll presses in the
middle on the backing paper. Retighten the
thumb screw.
13. Tighten the backing paper backwards and
close the lever [11].
[8] Peeling some labels off .
[9] Threading the backing paper underneath the printing
module.
A
[10] Spring-suspended block (A) at a ALX 924.
B
A
[11] Closing the pessure roller lever.