Avery Dennison ALX 924 Setup Manual - Manual (Page 17)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
17
Material Parameters
Using the following parameters, you can
tell the device which kind of labelling
material is supposed to be processed:
• PRINT PARAMETERS > Material type
Sets material type (punched or endless).
• PRINT PARAMETERS > Material length
Sets material length (measured from label
start to label start, that is label length plus
one gap length). Setting not relevant for
endless material.
• PRINT PARAMETERS > Material width
Sets material width.
P For details on how to set parameters, refer
to
Information on printouts and parameters
in the “Using the Parameter Menu” section.