Avery Dennison ALX 924 Setup Manual - Manual (Page 15)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
15
Adjustment button for
printhead pressure
The material width and / or material
thickness influence the pressure applied by
the thermal transfer printhead on the print
roller.
There are three possible settings for
pressure [23]:
I Setting for thin / narrow material
II Setting for material of medium width /
thickness
III
Setting for thick / broad material
Setting
The red adjustment knob [22A] [23] is
located above the ribbon roller in the front
plate and can be adjusted with a coin or
large screwdriver.
« To set medium pressure, turn the arrow
[23A] to position „II“ until it slots gently into
place.
« To set a higher pressure, turn the arrow to
position „III“ until it slots gently into place.
Factory settings
Setting „I“, for thin / narrow material
CAUTION! - Failure to set for the
correct pressure causes the printhead
to wear down more quickly and leads
thus to a shorter service life.
« Always select the lightest possible
pressure necessary to produce an
acceptable print result.
« Excessive pressure can lead to the
premature wearout of the printhead.
[22] A Adjustment knob for the printhead pressure
[23] A Adjustment knob for the printhead pressure
A
A