Avery Dennison ALX 924 Setup Manual - Manual (Page 16)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
16
Dispensing edge
By inclining the dispensing edge, the
dispensing position can be fine adjusted
without having to change the machine
position:
1. Undo the screws [24B] on both of the side
mounting plates. Access the screws from
beneath.
Tool: 2.5 mm Allen key
2. Turn the dispensing edge [24A] to the
desired position.
3. Tighten the screws.
Dispenser parameters
Set the following parameters prior to first
operating the machine.
• PRINT PARAMETERS > Dispense Mode
Determines sequence of the printer-
dispenser process (normal 1:1 mode,
batch mode or true 1:1 mode)
• PRINT PARAMETERS > Dispenseposition
Setting the adhesive edge, with which the
label after dispensing adheres to the
backing paper[25].
• SYSTEM PARAMETER > Start source
Setting the trigger signal source for the
printer-dispenser process (foot switch,
sensor or USI)
P For details on how to set parameters, refer
to
Information on printouts and parameters
in the “Using the Parameter Menu” section.
[24] Long dispensing edge (option) (feed roller disassembled
for better viewing).
B
A
[25] Dispensing position (=home position) shown schematically.
Dispensed label Dispense position
Dispensing edge
Backing paper
Z0040E
.cdr