Avery Dennison ALX 924 Setup Manual - Manual (Page 8)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
8
5. Open the front cover.
6. Set the material guide to the width of the
label material. To do this loosen the thumb
screw [5A] at the front material guide, shift
the material guide [5B] crossways to the
feed direction and tighten thumb screw
again.
¯
The label material should slide easily
between the material guides.
7. Press the opener [6A] to raise the contact
rollers [6B]. Push the beginning of the
label material through underneath the con-
tact rollers and the print head.
8. Position the contact rollers while pressing
down the opener [7].
¯
Both contact rollers should press down
the material symmetrically.
P Continued overleaf
[5] Adjusting the material guide (B).
A
B
[6] Inserting the label material at the print module.
A
B
[7] Positioning the contact rollers.