Avery Dennison ALX 924 Setup Manual - Manual (Page 14)

06/06 Rev. 3.05-01 OPERATING MANUAL Setup
ALX 92x
14
Label sensor
The ALX 92x is equipped with a light trans-
mission sensor for punch recognition:
Setting the label sensor
Turning the red adjustment wheel [20B]
moves the sensor up to 80 mm (4“/5“
modules) or 100 mm (6“ modules) across
the material. A dial [20A] displays the
value.
Reading the value:
… whereby the following applies:
• Punch position:
Distance of the punch from the (inner) edge
of the material [21A].
• Value:
Value on dial, set by rotating the red wheel.
Example: Punch centre = 11 mm from the
left edge; subtracting 2 mm gives a value of
9 mm.
« To make the setting, turn the wheel [20B]
until the desired value is aligned with the
mark [20A].
¯
Round labels: To ensure in those
cases, that the label start is correctly
identified, a punch offset can be preset.
This may be done by manually setting the
printer (Parameter
PRINT PARAMETERS >
X - print offset ) or by the appropriate control
command.
Value = punch position – 2 mm
[20] Setting the label sensor
A Dial
B Adjustment wheel
B
A
[21] Measuring the punch position (A).
A