Loading ribbon – Avery Dennison Monarch 9860 Quick Reference User Manual

Page 5

L o a d i n g R i b b o n

1. Open the cover.
2. Unlock the printhead by

turning the retaining
latch.

3. Lift printhead assembly

using the printhead tab
until the assembly locks
into place.

Printhead
Tab

Deflector
Tab

4. Push the deflector tab

down.

5. Slide the extra ribbon

core on the take-up reel
as far as it will go with
the "This End Out"
writing facing out. Use
your empty ribbon core as the take-up core. The take-up
core only fits on the take-up reel one way.

6. Remove the new ribbon from the package. Do not wrinkle

or crush the new ribbon.

7. Slide the ribbon onto the back reel as far as it will go.

The ribbon roll only fits on the reel one way. Carefully
unwind a few inches of ribbon from the bottom of roll.

Take-up
Core

Take-up
Reel

Ribbon
Rollers

Note:

Make sure the “Monarch This End Out” writing is
facing out. The ribbon roll only fits on the reel one
way.

8. Carefully feed the ribbon under both ribbon rollers and

printhead.