Avery Dennison Monarch 9860 Quick Reference - Manual (Page 11)

612 The data in this line of the batch is either
missing or does not match the format.
613 Reference point off supply.
614 Portion of field off supply or there may be an
invalid character in the packet.
703 The printer sensed a calibration of different-
sized black marks. Make sure the correct
supply type is loaded.
704 Printer has not sensed a supply mark when
expected or is out of supplies. Press Escape
(E) to continue printing. Change supply.
751 Printer did not sense a black mark when
expected. Press Escape (E) and try to
continue printing. Change supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Check for a ribbon jam or remove any slack in
the ribbon by turning the take-up reel clockwise.
Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies (supply length mismatch). Press
Feed (F).
758 Either the supply is not seen, the on-demand
sensor is broken, or a label was removed too
quickly. Check for a label jam or reload
supplies.
763 Waiting to dispense label. Press Feed (F).
764 Verifier scan error. Press Escape (E) to clear
the error and continue printing.
765 The printhead has less than 8 bad dots and can
shift bar code fields to avoid bad dots. Press
Escape (E) to continue printing.
768 Printhead has more than 8 bad dots within the
format area or is not connected. Connect
printhead.
11