Avery Dennison Monarch 9860 Quick Reference - Manual (Page 4)

11. Close the printhead by
pressing down on the
thumb well until you
hear it click into place.
12. Close the cover.
13. On the keyboard, press
Feed (F) to position
the supply under the
printhead and through
the knife.
A d j u s t i n g t h e W i d e / N a r r o w K n o b s
You may need to adjust the two wide/narrow knobs according
to the width of your supply. For supply that is more than two
inches, adjust the knobs to the wide setting. For supply that is
two inches or less, adjust the knobs to the narrow setting.
You must adjust both of the knobs to the same position.
If you experience ribbon
smudging in cold, dry
environments, adjust the
wide/narrow knobs to the
wide setting.
For wide supplies, push
down and turn the
wide/narrow knobs
clockwise with a
screwdriver.
For narrow supplies, turn
the wide/narrow knobs counter-clockwise with a screwdriver
until it pops back up.
The adjustment is shown in the wide position.
4