Avery Dennison Monarch 9860 Quick Reference - Manual (Page 10)

Problem Action
Light Printing.
-or-
Heavy Printing. Clean the printhead, change
supply, adjust the print contrast.
Check the wide/narrow knobs and
check the ribbon.
Voids in printing. Clean the printhead, change the
supply type, and check the ribbon.
Serial bar codes do
not scan. Leave printhead unlatched when
not in use, use a print speed of
2.5 IPS, and adjust the print
contrast.
Backing paper is
wrapped around
platen or peel roller. Carefully remove the backing
paper. Make sure the backing
paper tears at the saw-toothed
tear edge when using backfeed
and peel mode.
Blank labels print or
750 series errors. Clean the supply sensors.
C o m m o n E r r o r s
Error Description/Action
002 Name must be 1 to 8 characters inside quotes.
005 Supply width is invalid.
018 Code page selection defined in the field is
invalid.
025 Data length is too long.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unnecessary
formats or graphics from memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive buffer is full. Check for a flow
control problem.
611 Font, bar code, or density in the batch does not
fit the format.
10