Avalon Firestyles Ashpan - Manual (Page 5)

Avalon Ashpan Installation Instructions
Part # 99200125
Page 5 of 7 Printed September 4, 2008
2 Place the included screen (or other screen) over the hole to act as a rodent barrier. It may be attached
above or below the floor. Secure the screen with the included staples.
OUTSIDE AIR EQUIPMENT
Staples are used to
attach the screen to
the floor.
Screen is used to prevent
rodents from entering.
Insulation is used to seal the
side edges of the pedestal .
Cover plate is used
to block off room air .
3 Prop the front of the stove up 12" and pry out the ashpan pedestal knockout with a large screwdriver.
Standard Pedestal
Outside Air Knock-Out
Drop Chute
Knock-Out
Rear Blower Knock-Outs
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
FRONT OF STOVE
NOTE: If using
outside air, remove
this knock-out.
4 Follow the instructions on pages 1 through 4 of this instruction sheet for installing the ashpan
pedestal. With the pedestal in place, tuck the insulation included with the pedestal underneath the
side edges of pedestal to seal off any air from entering underneath the pedestal.
5 The cover plate seals the area around the air control rod. Remove the two screws and bridge from
the cover plate. Slide the cover plate underneath the air control rod and re-attach the bridge.
The cover plate has a clip which
attaches it underneath the air control.
Remove the two screws that hold the
bridge to the cover plate. Then replace
the bridge when the cover plate is in
place.
Air Control
Rod
Bridge
Phillips
Screwdriver