Avalon Firestyles Ashpan - Manual (Page 2)

Avalon Ashpan Installation Instructions
Part # 99200125
Page 2 of 7 Printed September 4, 2008
2 Pry out the drop chute knockout with a large screwdriver.
Standard Pedestal
Outside Air Knock-Out
Drop Chute
Knock-Out
Rear Blower Knock-Outs
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
FRONT OF STOVE
NOTE: If using
outside air, remove
this knock-out.
3 Open the door to the stove and remove the floor firebricks on the left side. Locate the drop chute
cover on the floor of the firebox. Remove the four bolts that secure it with a 7/16" wrench. Remove
the cover and the gasket below it. Insert the drop chute gasket around the drop chute. Then insert
the drop chute through the hole in the firebox floor. Position the drop chute so the slots run side to
side. Replace the four bolts to secure the drop chute.
Remove the four bolts
that hold the drop
chute in place.
7/16" Wrench
Drop Chute Cover
(Floor of Firebox)
Remove and discard
the drop chute cover.
Insert the Drop Chute into the hole. Secure it in place
with the four bolts that held the drop chute cover in
place.
Drop Chute
Make sure the gasket
forms a seal around
the perimeter of the
drop chute.
When installed the grates on the drop chute
should look like this when viewed from the side.
FRONT
Drop
Chute
Gasket