Avalon Firestyles DVS Cypress Face - Manual (Page 6)

DVS Cypress Face
Installation Instructions
(SKU 95200257)
Page 6 of 17 17601684 — 10/3/12 © Travis Industries, Inc.
Attach the Surround Panels (if applicable)
11. Attach the surround panel brackets (both sides) to the face brackets as shown below.
12. Hang the surround panel on the insert as shown below. The tabs on the panel are inserted into the
slots on the face brackets.
NOTE: Make sure the surround panel is aligned flush with the insert.
31 DVI and Australian units only:
Disconnect the On/Off switch* and rheostat from the wires.
Route the On/Off switch* and rheostat wires through the hole in the right side of the insert.
NOTE: Make sure to insert the wires through the rear hole.
* NOTE: Installers of Australian units may disregard this step.