Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 57)

Controls, LEDs and Connectors
RTM-ATCA-7350 Installation and Use (6806800H30G) 57
RTM_EN0_ and RTM_EN_ are signals that indicate the RTM is firmly inserted.
3.3.2 P31 Pinout
P31 is used for port1 and port2 signals of the Fabric interface, and the PCIE signals from MCH.
PinA1 on the sever board side is on the top of the connector, and on the left column of the P31
connector while the server board is placed top side upwards and the front panel is on the left.
Table 3-4 PIN 30 Pinout
HM A B C D E
1 VSB5V RTM_EN0 GND RTM_OOSR_ RTM_HEALTHY_G_
2 VSB5V RTM_HOTSPWAP_ GND RTM_HEALTHY_R RTM_OOSY_
3 +12V RTM_TOP_EJECTO
R_ GND RTM_SDA RTM_SCL
4 +12V RT;_EPROM_WE GND VGA_RED CPLD_RTM_TDI
5 +12V RTM_BOT_EJECTO
R_ GND VGA_BLUE RTM_JTAG_TDO
6 +12V RTM_KBCLK GND VGA_GREEN CPLD_RTM_TCK
7 +12V RTM_MSDAT GND VGA_HS CPLD_RTM_TMS
8 +12V RTM_MSCLK GND VGA_VS CPLD_RTM_TRST
9 +12V RTM_KBDAT GND VGA_DDCCLK RTM_PWR_GOOD
10 +12V RTM_USB_P GND VGA_DDCDAT RTM_LM80_INT_
11 +12V RTM_USB_N GND RTM_SBY_RST RTM_EN_
Table 3-5 PIN 31 Pinout
ZD1 A B C D
1 RTM_SYSLED_
G_ RESERVED GND RTM_SYSLED_R
_ RESERVED GND
2 RTM_FC2_TX2
_H RTM_FC2_TX2_L GND RTM_FC1_TX2
_H RTM_FC1_TX2_L GND
3 RTM_FC2_RX2
_H RTM_FC2_RX2_L GND RTM_FC1_RX2
_H RTM_FC1_RX2_L GND