Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 40)

Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30G) 40
11.Close the handles of the front blades. The LEDs; OOS LED, Blue LED, and healthy
LED of RTM are on.
12.Wait until the blue LED on the RTM is OFF.
A switched off blue LED indicates that the payload of the RTM has become active.
2.7.2 Removing RTM-ATCA-7350
To remove RTM-ATCA-7350, proceed as follows:
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 24 .
2. Unlatch the lower handle outward by squeezing the lever and the latch together
and turning the handle outward only enough to unlatch the handle from the face
plate, that means until you feel a resistance. Do not rotate the handle fully outward.
The blue LED blinks indicating that the shelf manager is informed about the desire
of the blade to power down the payload of both the front blade and the RTM and
the power-down process in ongoing.
3. Wait until the blue LED of the RTM is permanently ON. A permanently switched ON
LED indicates that the payload of the RTM has been powered down.
4. As shown in step 2 of the figure below, use the screwdriver to unfasten the captive
screws of the RTM anticlockwise.
5. As shown in step 1 of the figure below, fully open the upper and lower ejector
handles.
Product Damage
You should power off the front blade before removing RTM-ATCA-7350.