Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 49)

Controls, LEDs and Connectors
RTM-ATCA-7350 Installation and Use (6806800H30G) 49
3.2.1 LEDs
The face plate of RTM-ATCA-7350 provides the following indicators:
 Out of service (OOS) indicator
 In service (IS) indicator
 Hotswap (H/S) indicator
The GE daughter card provides the network port indicators and the FC daughter card provides
the FC status indicators. You can monitor these indicators to diagnose the current status of
RTM-ATCA-7350.
The following table lists the indicators on the RTM-ATCA-7350 face plate.
Table 3-1 Indicators on the RTM-ATCA-7350 Face Plate
Indicator Color Meaning Description
OOS Red or amber Service status
indicator  The RTM-ATCA-7350 turns the red LED on
when transitioning from FRU M3 to M4 state
if in local control state. It is the responsibility
of the application to change the status of the
LED via IPMI command.
 The RTM-ATCA-7350 turns the LED off when
transitioning from FRU state M6 to M1 if in
local control state.
IS Red, green or
amber In service indicator The IS LED is off when the payload processor
starts running.
Payload Management software is
responsible for controlling the IS LED.
H/S Blue Hot swap indicator  Off: RTM-ATCA-7350 is in activated state.
 On: RTM-ATCA-7350 is inserted, but in
deactivated state or not powered on.
 Blinking at the long blink rate 1 : RTM-ATCA-
7350 is requesting activation.
 Blinking at the short blink rate 2 : RTM-ATCA-
7350 is requesting deactivation.