Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 56)

Controls, LEDs and Connectors
RTM-ATCA-7350 Installation and Use (6806800H30G) 56
3.3 Zone 3 Connectors
Zone 3 is composed of three connectors, P30, P31, and P32. The three connectors are used to
connect RTMs with RTM-ATCA-7350s. Zone 3 defines the following signals:
 USB (USB)
 VGA
 IPMC SMBus
 Power (VCC 12VDC, VSBY 5V5)
 PCI-E Channels
 General control signals (RTM PRESENT, RTM RST, LEDs)
 Fabric channel port 0, port 1, port 2, port 3 for the ATCA-7350
3.3.1 P30 Pinout
P30 uses a common 2mm HM connector. P31 uses a half-height ZD connector. P32 uses a ZD
connector.
Refer to the PICMG specification for the location of the connectors.
The following table shows the P30 pinout. PinA1 on the server blade side is on the top of the
connector while the server blade is placed top side upwards and the face plate is left.
12 DDC DATA DDC data pin for CRT.
13 HS Horizontal sync for Monitor.
14 VS Vertical sync for Monitor.
15 DDC CLK DDC pin SCL for CRT.
Table 3-3 VGA Port Pin Assignment (continued)
Pin Pin Name Description