Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 32)

Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30G) 32
2.6.3.2 Installing the GE Daughter Card
To install the GE daughter card, proceed as follows.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 24 .
2. Lay RTM-ATCA-7350 where the GE daughter card is to be installed on the antistatic
desktop.
3. As shown in step 1 of the figure below, insert two plastic supports vertically in the
holes used to fasten the GE daughter card.
4. As shown in step 2 of the figure below, at the back side of RTM-ATCA-7350, use a
screwdriver to clockwise fasten the two screws used to fix the plastic supports.
5. Take the GE daughter card out of the antistatic package.