Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 35)

Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30G) 35
After replacement, check if RTM-ATCA-7350 can be powered on and work normally. Use the
network cable to connect RTM-ATCA-7350 to the external network. Check if the network is
connected properly and monitor whether the network port indicator is normal.
2.6.4 FC Daughter Card
This section describes how to install the daughter card on and remove it from RTM-ATCA-7350.
2.6.4.1 Installation Positions
When the FC daughter card is used with the RTM-ATCA-7350 it can be installed on the
daughter card connector J1. The RTM-ATCA-7350 provides space for one FC daughter card.
Use of the FC daughter card excludes use of the GE daughter card.
2.6.4.2 Installing the FC Daughter Card
To install the FC daughter card, proceed as follows.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 24 .
2. Lay RTM-ATCA-7350 where the FC daughter card is to be installed on the antistatic
desktop.
3. Insert two plastic supports vertically in the holes used to fasten the FC daughter
card.
4. At the back side of RTM-ATCA-7350, use a screwdriver to clockwise fasten the two
screws used to fix the plastic supports.
5. Take the FC daughter card out of the antistatic package.