Artesyn RTM-ATCA-7350 Installation and Use (September 2014) - Manual (Page 39)

Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30G) 39
7. Align the upper and lower sides of RTM-ATCA-7350 with the guide rails (the edges
of the slot). Slide RTM-ATCA-7350 along the guide rails until the positioning pins of
RTM-ATCA-7350 are inserted in the positioning holes in the shelf.
8. Make sure that the ejector handles are fastened to the beam. Close the upper and
lower ejector handles inwards until the inner sides of the ejector handles are
attached to the face plate.
9. Use the screwdriver to fasten the captive screws clockwise to fix RTM-ATCA-7350.
The LEDs of the RTM are off now.
10.Insert the main blade. For instructions on how to install the main blade, refer to
Installing the ATCA-7350 in a Powered Shelf in ATCA-7350 Installation and Use manual.
Figure 2-5 Installing RTM-ATCA-7350