Artesyn COMX-CAR-210 Installation and Use (August 2014) - Manual (Page 36)

Controls, LEDs, and Connectors
COMX-CAR-210 Installation and Use (6806800L14D) 36
3.4.3 LAN
3.4.4 PCI Express
Jumpers P13 and P25 are used to configure the PCIe MUX devices.
Table 3-15 J1, LAN Connectors Pin-Out
Pin Signal Pin Signal
9 GBE0_CTREF 16 LAN_MDI3_P
10 LAN_MDI0_P 17 LAN_MDI3_N
11 LAN_MDI0_N 18 GND
12 LAN_MDI1_N 19 LAN_LED_LINK1000_N
13 LAN_MDI1_N 20 LAN_LED_LINK100_N
14 LAN_MDI1_P 21 VCC3V3_DUAL
15 LAN_MDI2_N 22 LAN_LED_ACT_N
Table 3-16 P13, PCIe MUX Configuration
Jumper Setting Configuration
P13 (1-2) SDVO Output
P13 (2-3) PEG Output (Default)
Table 3-17 P25, PCIe MUX Configuration
Jumper Setting Configuration
P25 (1-2) PCIE X1 slot (Default)
P25 (2-3) PCIE Mini-card