Artesyn COMX-CAR-210 Installation and Use (August 2014) - Manual (Page 33)

Controls, LEDs, and Connectors
COMX-CAR-210 Installation and Use (6806800L14D) 33
3.4.1.2 VGA
3.4.1.3 SDVO to DVI
Table 3-7 P26, 5V Stand-by Jumper Setting
Jumper Setting Configuration
P26 (1-2) Enable 5V_standby to
module (default
P26 (2-3) Disable 5V_standby to
module
Table 3-8 J5, VGA Connector Pin-out
Pin Signal Pin Signal
1C CRT_R 2C CRT_G
3C CRT_B 4C NC
5C GND 6C GND
7C GND 8C GND
9C 5V 10C NC
11C NC 12C DDCDATA
13C HSYNC 14C VSYNC
15C DDCCLK
Table 3-9 P13, SDVO to DVI Jumper Setting
Jumper Setting Configuration
P13 (1-2) Switch to DVI
P13 (2-3) Switch to PEG (Default)