Artesyn COMX-CAR-210 Installation and Use (August 2014) - Manual (Page 22)

Hardware Preparation and Installation
COMX-CAR-210 Installation and Use (6806800L14D) 22
2.1.2 Power Requirements
The COMX-CAR-210 uses a single 12V power solution where all types of power except the
standby power on the board are generated from the VCC12V. This design consideration is for
the single power input application on most of the industrial usage.
2.2 Unpacking and Inspecting the Board
1. Verify that you have received all items of your shipment:
 Printed Quick Start Guide and Safety Notes
 COMX-CAR-210 COM Express Carrier Board
 Accessories:
– URAT cable, 2x5 pin housing for DB9 pin connector, with I/O panel, 300 mm
length
– USB cable, 2x5 pin housing for USB x2 connector, with I/O panel, 300 mm length
Table 2-2 Power requirement
Voltage 12V 5V_STB
Maximum Current 15A 2A
Maximum Power con-
sumption 190W
Damage of Circuits
Electrostatic discharge as well as incorrect installation and removal of the product can dam-
age circuits or shorten its life.
Before touching the product, make sure that you are working in an ESD-safe environment;
and wearing ESD wrist strap or ESD shoes. Hold the product by its edges and do not touch
any components or circuits.