Artesyn COMX-CAR-210 Installation and Use (August 2014) User Manual
Page 23
Hardware Preparation and Installation
COMX-CAR-210 Installation and Use (6806800L14D)
23
–
LPT cable, 2x13 pin housing for DB25 pin connector, with I/O panel, 300 mm
length
–
PS/2 cable, mini DIN6P to PS/2 connector, 300 mm length
–
COMX-CAR-210 Carrier Board I/O board shield
2. Check the product for any damage or differences, and immediately report any to customer
service.
3. Remove the desiccant bag shipped together with the product.
2.3
Installation and Removal of the COM Express
Module
The assembled COM Express module with the attached heat spreader is attached to a carrier
board.
Installing the COM Express Module on the Carrier Board
1. Line up the board-to-board connector for the COM Express module with the board-to-
board connector of the COMX-CAR-210.
2. Make sure that the interconnectors are properly aligned, and that the standoffs have
contact with the top of the COMX-CAR-210.
3. Turn over the COM Express module and the COMX-CAR-210.
4. Locate the screw holes from the back side of the COMX-CAR-210.
5. Use the screws to fasten the COM Express module assembly to the COMX-CAR-210.
Environmental Damage
Improper disposal of used products may harm the environment.
Always dispose of used products according to your country’s legislation and manufacturer’s
instructions.