Configuring rip – ARRIS WTM652 User Guide User Manual

Page 49

Configuring RIP

Enabling RIP (Router Information Protocol) allows the WTM652 to act as a router

in your local network. RIP is primarily intended for use in an office environment.

Requirements

To successfully configure RIP, you must:

• have a static IP address assigned by your cable provider
• disable Network Address Translation (NAT) on the WTM652 (which means

you must either assign static IP addresses to all devices in your local net-

work or use a DHCP server to assign addresses)

Action

Follow these steps to configure RIP.

1 Click the Lan Setup link in the navigation menu, then click RIP Settings.

The RIPv2 Settings window appears:

Touchstone WTM652 Telephony Modem User’s Guide