AMETEK SLM-1 - Manual (Page 75)

APPENDIX E
SLD-SERIES GPIB/RS-232
OPERATING FLOW CHART
The following flow chart shows the typical SLM-Series chassis remote control and load
current level and status setting procedures of each SLD-series load module.
START
CC MODE?
CR MODE? CV MODE?
NO
YES
Set
"MODE CC"
Set
"MODE CV"
Set
"MODE CR"
YES
YES
STATIC or
DYNAMIC?
DYNAMIC
STATIC
Set
"DYN OFF"
"CC:NR2"
Set
"CHAN A"
Set
"CHAN B"
CHAN A or
CHAN B?
Set
"DYN ON"
"CC:HIGH NR2"
"CC:LOW NR2"
"PERI:HIGH NR2"
PERI:LOW NR2"
"SLEW NR2"
Set
"DYN OFF"
"CV:NR2"
Set
"DYN OFF"
"CR:NR2"
Module Setups
Load On/Off
Voltage
Set
"LDONV NR2"
"LDOFV NR2"
Vsense
Set
"SENS ON|OFF"
Good/No Good
Set
"NGAB ON|OFF"
"LIM:CURR:HIGH NR2"
"LIM:CURR:LOW NR2"
"LIM:VOLT:HIGH NR2"
"LIM:VOLT:LOW NR2"
Is CHB/ CHA
Set?
Set
"LOAD ON"
NO
OCP Setup
Set
"OCP:START NR2"
"OCP:STOP NR2"
"OCP:STEP NR2"
"OCP:VTH NR2"
Set Test Mode
"TCONFIG nor/OCP"
Store Setup
"STOR m,n"
Run OCP/OPP Test
"REC m,n"
REM
Remote Indicator
on Front Panel
NO
M540070-01 Rev B E-1