AMETEK SLM-1 - Manual (Page 17)

SECTION 2
INSTALLATION
2.1 INSPECTION
The SLM-1 chassis was carefully inspected before shipment. If instrument damage
has occurred during transport, please inform the Xantrex sales and service office or
representative per the Warranty instructions of this manual. SLM-1 chassis was
shipped with a power cord for the type of outlet used at your location. If the appropriate
cord was not included, please contact your nearest Xantrex sales representative to
obtain the correct cord. Refer to Section 2.1.1 to check the line voltage selection and
fuse type.
2.1.1 Line Voltage
The SLM-1 chassis can operate with 100/200Vac or 115/230Vac input as indicated
on the rear pane label l (Figure 2-1). Make sure that the factory mark corresponds to
your nominal line voltage. If not correctly marked, perform the following procedures:
1. With the SLM-1 chassis power OFF, disconnect the power cord.
2. Set the switches on the rear panel to the proper voltage as follows:
a. Set Switch to 100V/115V for 100Vac or 115Vac line voltage
b. Set Switch to 200V/230V for 200Vac or 230Vac
M540070-01 Rev B 2-1