AMETEK SLM-1 - Manual (Page 18)

Configuration Sorensen SLM-1 Chassis
Figure 2-1 Input Power Setting Switch
3. Check the rating of the line fuse and replace it with the correct fuse if necessary.
4. The AC line fuse is located below the AC line receptacle (Figure 2-2). With the
power cord removed, use a small screwdriver to extract the fuse holder from
under the AC socket. Replace the fuse with the appropriate type as indicated in
Table 1-2. These fuses are normal-blow fuses.
5. Reinstall fuse holder and reconnect the power cord.
Figure 2-2 Fuse Holder in AC Line Input Connector
2.1.2 Grounding Requirements
The SLM-1 chassis is equipped with a three-conductor cable that plugs into an
appropriate receptacle to ground the instrument's cover.
2-2 M540070-01 Rev B