AMETEK SL Series Software - Manual (Page 30)

Calibration Procedure Elgar Electronics Corporation
2.3.5
C
ONSTANT
R
ESISTANCE
(CR) M
ODE
C
ALIBRATION
, C
HANNEL
B
Make the appropriate connections per Figure 2-22, Figure 2-23, or
Figure 2-24, for the Load module being calibrated.
Note: ** Vsense must be connected with DC INPUT COM.
Set the load to CR mode by pressing the MODE key until the CR is lit.
Figure 2-22. Channel B CR Mode Connections for SLD-60
Figure 2-23. Channel B CR Mode Connections for SLD-61
Figure 2-24. Channel B CR Mode Connections for SLD-62
2-22 SLD Calibration Manual