AMETEK SL Series Software - Manual (Page 18)

Calibration Procedure Elgar Electronics Corporation
2.2.5
C
ONSTANT
R
ESISTANCE
(CR) M
ODE
C
ALIBRATION
, C
HANNEL
A
Make the appropriate connections per Figure 2-10, Figure 2-11, or
Figure 2-11, for the Load module being calibrated.
Note: ** Vsense must be connected with DC INPUT COM.
Set the load to CR mode by pressing the MODE key until the CR is lit.
Figure 2-10. Channel A CR Mode Connections for SLD-60
Figure 2-11. Channel A CR Mode Connections for SLD-61
Figure 2-12. Channel A CR Mode Connections for SLD-62
2-10 SLD Calibration Manual