AMETEK SL Series Software - Manual (Page 28)

Calibration Procedure Elgar Electronics Corporation
2.3.4
C
ONSTANT
V
OLTAGE
(CV) M
ODE
C
ALIBRATION
, C
HANNEL
B
1.
Connect the load to the DMM and DC power supply per Figure 2-19,
Figure 2-20, or Figure 2-21, for the Load module being calibrated.
Note: Figure 2-19 refers to both SLD-60 and SLD-80.
2. Set the power source current limit to 0.1A
3. Set the load to CV mode by pressing the MODE key until CV is lit.
Figure 2-19. Channel B CV Mode Connections for SLD-60 or SLD-80 Calibration
Figure 2-20. Channel B CV Mode Connections for SLD-61 Calibration
Figure 2-21. Channel B CV Mode Connections for SLD-62 Calibration
2-20 SLD Calibration Manual