AMETEK SFA Series - Manual (Page 29)

Sorensen SFA Series Installation
M550292-01 Rev G 2-5
CAUTION!
Prevent damage to the unit: follow torque specifications, use correct size
wire ferrule (if used), and proper size ferrule crimping tool.
T ORQUE S PECIFICATIONS
• The unit’s Phoenix Connectors require 18 in-lb to 20 in-lb (2 Nm to
2.3 Nm) torque.
• Wire ferrules are recommended; their size must match the wire
gauge.
• Crimp tool size must be appropriate to the ferrule size.
•
Wire insulation should be stripped back no more than 5/8 inch for
the ferrule.
For more information on this AC input connector, please look up Phoenix
Contact part number HDFKV 16 at www.phoenixcontact.com.