AMETEK HPD Series GPIB-Multichannel User Manual
Page 87
Status Registers
Status Register Commands
83
To clear the Service Request Enable Register send "*SRE 0." The Power-on Status
Clear command also determines if the Service Request Enable Register is cleared at
power-on. A cleared register does not allow status information to generate a service
request.
E.g.
Sending "*SRE 8" sets bit 3 of the Service Request Enable Register. This will cause
the Summary bit of the Questionable Status register (bit 3) in the Status Byte to
generate a service request message whenever it gets set.
*SRE
or the multichannel equivalent:
STATus
STATus
Parallel Poll Enable Register
Each of the 16 bits in the Parallel Poll Enable register correspond to bits in the Status
Byte. Each bit in the Parallel Poll Enable register is ANDed with its corresponding
bit in the Status Byte and the resulting bits are ORed together to generate ist.
Therefore using the parallel poll enable register allows any single bit or combination
of bits to control the ist message.
The Power-on Status Clear command determines if the Parallel Poll Enable Register
is cleared at power-on.
E.g.
Sending "*PRE 8" sets bit 3 of the Parallel Poll Enable Register. This will cause the
Summary bit of the Questionable Status register (bit 3) in the Status Byte to generate
a TRUE ist message whenever it gets set.
Command: *PRE
Status Byte
The status byte query will return the contents of the status byte register and the MSS
(Master Summary Status) message. The response is in the format of a weighted
decimal value representing the status byte register and the MSS message (bit 6).
Thus, the response to *STB? is identical to the response to a serial poll except that
the MSS message appears in bit 5 in place of the RQS message. (See “Status Byte”
on page 79 for details.)
*STB?